Fiber Transceiver/Module exclusive inspection microscope


As the widespread of high-speed transmission LC optical transceiver module, the inspection of its performance index is very important. It is super critical to check the whole range and large field of view of the end face when the optical fiber is connected to the port. The two-in-one dual-use magnification bench integrated microscope is the perfect inspection toolwhich is exclusively for the edge and core two area inspection.

The diameter of the end face LC module is less than 1mm, once defects are around or at the edge, such as crevasse, crack, or larger dirt, it is very likely to spread and shift the risk to the central position of the core, which causes the unqualified transceiver finally. Therefore, the full range, whole large field of view module end inspection is a must to the high-end transceivers module manufacturers for the QC process and final product audit acceptance.


Large field of view, full range observation, especially for the LC transceiver to check the edge, such as crack, crevasse or larger dirt.



                Up and down operation needs

                Image magnification:176X


                Field of View940µm X 690µm



               Whole edge can be checked, no need                  for up and down

                Image magnification:120X


                Field of View1375µm X 1010µm


               The opening position of ferrule ring                     can be observed

              Image magnification:96X


               Field of View1720µm X 1260µm

The two-in-one double transceiver module inspection microscope, adds a small rate of 70X or 50X on the traditional 200X scope for two use. Large magnification checks the detailed core area like scratch, dirt, etc., defects while the small rate ensures the whole end face edge(70X) or ferrule ring(50X) for crack, dirt, etc., abnormality. Two images synchronous output on two displays and can be quickly viewed in seconds. It solves the long-time headache test problems for the up and down, left and right position of the inspection kits, which is time-consuming and labor-consuming. It’s the perfect transceiver module inspector tool and achieves the real goal for low cost and high-efficiency inspection requirements.

For one-hand rotating devices kits, one-hand non-stop focusing of the component end-face inspection, the integrated double magnification microscope, is a real sharp tool to end the difficult and complex unnecessary operation, also for the high-end transceiver module, components end face inspection check.

Next:This is the last one
Prev:This is the first article